NCR 6003-K001-V003, Installation Instructions Manual

Page: 16 / 163

2
HEATER KIT CONTENTS
Note: One heater kit is used per dispenser.
Caution: Do not proceed unless two NCR OPTIC5 or OPTIC12 kits are being installed (or
already installed) into the applicable dispenser.
115 Volt OPTIC Heater Kit Contents (497-0521546; 6003-K001-V003)
ITEM P/N QTY DESCRIPTION
1 006-8611215 8 SCREW,6-32X0.500, MACHINE, PHIL, PAN, STL, (4 Used)
2 006-8611426 8 NUT - #6-32 KEP LOCK (4 Used)
3 006-8611458 4 CABLE CLAMP, 3/16" (2 Used)
4 006-8627165 3
SCREW, HI-LO #6-I9 X 3/8", PAN HEAD POZIDRIV, ZINC-PLATED (2
Used)
6 006-8616073 12 CABLE TIE - 2.5MM WIDTH, 100MM LENGTH (9 Used)
14 006-8627144 10 SCREW, M4X12, PANHEAD, POZIDRIV, ZINC-PLATED (2 Used)
15 497-0522505 1 SHIELD BRACKET MOUNT, OPTIC HEATER
16 006-8617730 2 LOCKNUT, 8-32 KEPS, CLEAR TRIVALENT
18 497-0522788 1 OFFSET LINK PLATE, OPTIC HEATER
19 497-0522796 1 WIRE GUARD, OPTIC HEATER
20 006-8626667 4
SCREW, #8-32X3/8", TORX, THREAD-FORMING, ZINC-PLATED STEEL
(4 Used)
21
NCR Heater
Assembly
1 OPTIC Heater
22 497-0524577 1 OPTIC heater Mounting plate
23 497-0529988 1 Heater Mount, Helix Standard
24 006-8627136 2 NUT, M4 BINX
25 007-7023310 1 M2.9x6mm Self Thread cutting screw
Notes regarding placement or mounting location of thermostat:
•
For all dispensers, the thermostat mounting location must be lower than the
heater. This will ensure that the thermostat is at a colder location within the
dispenser and does not shut off the heater due to warmer air flow from the
heater.
•
The thermostat should not be mounted in front of the hot air exit of the heater.
This will ensure that the thermostat does not read an artificially warm dispenser
cavity temperature.
•
Follow thermostat placement instructions in this guide for optimal heater
operation.
Notes regarding heater operation:
1. CAUTION: After all cables are reconnected, double check that no cables are
hanging or lying in front of the heater exit. Any remaining cables hanging in