Service Manual Chapter8. CDU
© 2016
Nautilus Hyosung Inc.
All Rights Reserved.
8-17
► CS8 (Encoder sensor)
1. Remove the M3 screw of the CS8 sensor bracket (1 place).
2. Remove the connector and the cable toe to remove the sensor bracket. Be careful
not to break the connector pin when removing.
3. Press part
②
of the sensor gently as shown in the figure below to remove the lock
and the sensor.
4. To insert the sensor, insert the part
①
first, then press part
②
to lock.
5. Assemble in the reverse order - 3~1.
<Note!>
Make sure that the sensor always faces towards the center of the encoder
shaft as shown in the following figure.
ENCODER
44135304