Chapter8. CDU Service Manual
8-10
© 2016
Nautilus Hyosung Inc.
All Rights Reserved.
►CS2D
1. Remove the M3 screws (4 places) of the sensor bracket.
2. Remove the connector and the cable tie to remove the sensor supporter. Be careful
not
to break the connector pin when removing.
3. Remove the M3 sensor screw (1 place).
4. Remove the M3 sensor fastening screws from the removed sensor bracket.
5. Replace the sensor.
6. Assemble the unit in the reverse order - 4~1. Make sure to fasten the spacer and the
screw end is not protruding out to the other side of the bracket.