Chapter8. CDU Service Manual
8-16
© 2016
Nautilus Hyosung Inc.
All Rights Reserved.
Gate Operation Detection Sensor & Encoder Sensor
► CS3
1. Remove the M3 screw of the CS3 sensor bracket (1 place).
2. Remove the connector and the cable tie to remove the sensor bracket. Be careful
not to break the connector pin when removing.
3. Press the part
②
of the sensor gently as shown in the figure below to remove the
lock and the sensor.
4. To insert the sensor, insert the part
①
first, then press part
②
to lock.
5. Assemble in the reverse order - 3~1.
<Note!>
When reassembling the CS3, pull the solenoid and adjust the detection bracket to the
center of the sensor while the screw is still loose. Then, tighten the screw.
