Chapter8. CDU Service Manual
8-12
© 2016
Nautilus Hyosung Inc.
All Rights Reserved.
►CS4D (A, B)
1. Remove the M3 screws (2 places) of the sensor bracket.
2. Remove the connector and the cable tie to remove the sensor supporter. Be careful
not to break the connector pin when removing.
3. Remove the sensor bracket.
4. Remove the M3 sensor fastening screws to replace from the removed sensor
bracket.
5. Replace the sensor.
6. Assemble the unit in the reverse order - 4~1. Make sure to fasten the spacer and the
screw end is not protruding out to the other side of the bracket.
