5.5.1 Introduction ......................................................................................................................... 61
5.5.2 Basic Parallel Operation ................................................................................................... 61
5.5.2.1 Master Unit Set Up ......................................................................................................... 61
5.5.2.2 Slave Unit Set Up ............................................................................................................ 62
5.5.2.3 Setting Over Voltage Protection............................................................................... 62
5.5.2.4 Setting Foldback Protection ...................................................................................... 62
5.5.2.5 Connection to Load ....................................................................................................... 62
5.5.3 Advanced Parallel Operation......................................................................................... 64
5.5.3.1 Master Unit Set Up ......................................................................................................... 64
5.5.3.2 Slave Unit Set Up ............................................................................................................ 64
5.7.1 External Shut Off Function .............................................................................................. 66
5.7.2 Interlock Function - Analog On/Off. (Enable/Disable) .......................................... 66
5.7.3 Auxiliary Programmed Function Pin 1 and Pin 2 .................................................... 67
5.7.4 Power Supply OK Signal ................................................................................................... 68
5.9.1 Default Setting .................................................................................................................... 69
5.9.2 Reset ....................................................................................................................................... 69
5.9.3 Last Setting Memory ........................................................................................................ 69
5.9.4 Save <1..4> ............................................................................................................................ 70
5.9.5 Recall <1..4> ......................................................................................................................... 70
CHAPTER 6: REMOTE ANALOG PROGRAMMING
6.1 Introduction ................................................................................................................................... 72
6.2 Local/Remote Analog Control ................................................................................................ 72
6.3 Local/Remote Analog Indication ........................................................................................... 72
6.4 Remote Voltage Programming of Output Voltage and Current ................................ 73
6.5 Remote Resistor Programming of Output Voltage and Output Current ................ 74
6.6 Programming Monitoring of Output Voltage (V_MON) and Current (I_MON) .... 75
CHAPTER 7: Serial RS232/RS485 and USB Interface
7.2.1 Default Setting .................................................................................................................... 76
7.2.2 Address Setting................................................................................................................... 76
7.2.3 Communication Interface Selection .......................................................................... 76
7.2.4 Baud Rate Setting ............................................................................................................... 77
7.2.5 Language Selection (RS232/RS485, USB) .................................................................. 77
7.2.6 Setting Unit in Remote, Local Lockout or Local Mode ......................................... 77
7.3 Rear Panel RS232/485 Connector ........................................................................................... 78
7.4 Connectig Power Supply To RS232 Or RS485 BUS ........................................................... 79
7.5 Rear Panel USB Connector ........................................................................................................ 80
7.6 Multi Power Supply Connection to RS232, RS485, LAN, or USB .................................. 80
7.7 GEN Protocol (GEN series communication language) .................................................... 81
Summary of Contents for RMX-410 Series
