95
NATIONAL
INSTRUMENTS
7.12 SCPI Subsystem Commands
Subsystem commands are specific to power supply functions. They can be a single command
or a group of commands. Groups are comprised of commands that extend one or more levels
below the root.
Commands followed by a question mark (?) take only the query form. Except as noted in the syntax
descriptions, all other commands take both the command and query form.
7.12.1 Output Subsystem
OUTPut
This command enables or disables the power supply output. When output is turned off, voltage
display shows ”
OFF
”.
SCPI Command Syntax
OUTPut[:STATe] <bool>
GEN Command Syntax
OUT <bool>
Parameters
0|OFF
1|ON
*RST Value
OFF
Examples
OUTP 1 OUTP:STAT ON
Query Syntax
OUTPut[:STATe]?
Returned Parameters
0|1
OUTPut:PON[:STATe]
• AUTO - The power supply output will return to its previous value when the latching fault
condition is removed or to the stored value after AC recycle.
• SAFE - The power supply output will remain Off after the fault condition is removed or
after AC recycle.
SCPI Command Syntax
OUTPut:PON[:STATe] <bool>
GEN Command Syntax
AST <bool>
Parameters
0|OFF
1|ON
*RST Value
OFF
Examples
OUTPut:PON 1
Query Syntax
OUTPut:PON[:STATe]?
Returned Parameters
0|1
OUTPut:PROTection:CLEar
This command clears the latch that disables the output when an over voltage (OVP), under voltage
(UVP), or foldback (FOLD) fault condition is detected. All conditions that generate a fault must
be removed before the latch can be cleared. The output is then restored to the state before the
fault condition occurred.
SCPI Command Syntax
OUTPut:PROTection:CLEar
GEN Command Syntax
None
Parameters
None
Summary of Contents for RMX-410 Series
