NARDA LR-01, User Manual

Page: 152 / 194

9-24 Command protocol
SAVG l;r
This setting command sets the averaging mode.
•
l is the time length in minutes, between 0.25 and 30 with 0.25 minutes resolution
up to 1 minute; 1 minute up to 15 minutes and always 30 minutes over 15.
•
r is the averaging type. A for AVG, R for RMS or I for Instantaneous.
The reply is the same as per ?AVG command.
Note: if the instantaneous mode is set, the L parameter has no effect.
Example:
#LRSAVG1;R* which means the unit is set to average over 1 minute with a
RMS average type.
SBDR b
This setting command sets the optic serial port speed.
The parameter b is a code for the bit rate; in details:
•
b=10 : 9600 bps
•
b=11 : 38400 bps
•
b=12 : 57600 bps
•
else : 115200 bps
The reply is:
BDR=OK if the command has been granted
BDR=ERR if the command has been refused
Example: #LRSBDR 10* which means the optical port speed is set to 9600 bps.
Default speed is 115200 bps. The parameter is kept also when the unit is switched OFF.
Like other essential settings, it can be reset when the unit is turned on by keeping the
button pressed.
SBLE x
This setting command switches the internal BLE (Bluetooth Low Energy) module ON or
OFF as following:
•
x = ON: switches the module ON and starts the ”advertising” procedure, making
the unit visible to other Bluetooth devices.
•
x = OFF closes any open channel and turns OFF the module.
Once the pairing process has started, the password to connect is “123456”.
The reply BLE=OK indicates that the command has been granted.
Example:
#LRBLEOFF* which means that any open wireless channel will be closed and
the module will be turned off.
If the Wireless firmware release is older than 1.3.0, the reply is preceded by the string:
***WARNING LEGACY WIRELESS FIRMWARE***\r\n