9-4
Command protocol
Table 9-2 Setting COMMANDs
Syntax
Function
SADR
a
Sets unit’s address.
SALR
s
Sets alarm threshold.
SALT
Resets the reference altitude.
SAQ_
x;t
Sets the logger parameters.
SAVG
l;r
Selects averaging mode.
SBDR
b
Sets baud rate.
SBLE
x
Switches Bluetooth ON or OFF.
SCLD
d.m.y
Sets the RTC date.
SCLT
h.m.s
Sets the RTC time.
SCPC
t
Runs compass calibration.
SDCM
c
Sets the preferred communication channel at power on.
SGCSA
h
Automatic time set.
SGCSM
Manual time set.
SGOF
Switches OFF the GPS module.
SGOOFF
Switches OFF the unit.
SGOI
Switches ON the GPS module.
SIAMk para
Set the LR01/IAM output and alarm(s)
SIDN
i
Sets the units identifier.
SKFR
f
Sets the frequency correction value and makes it active.
SLPF
f
Selects the Low Pass Filter for passive probes.
SLST
l
Instantly activates or deactivates the log.
SMSK
m
Sets the warnings and alarms mask.
SPWD
p
Sets Wi-Fi password.
SREBOOT
Reboots the unit.
SRST
Restores default configuration.
SRSTR
Restores default configuration and logger rate.
SSID
i
Sets Wi-Fi network ID.
SSTS
i
Set the reference standard (for EHP-2B model probe only)
SWFI
x
Wi-Fi connection.
SWRN
s
Sets warning threshold.
Summary of Contents for LR-01
