NARDA LR-01, User Manual

Page: 14 / 194

1-6 General information
The following list shows the 8059 probes:
TABLE 1-2 8059 Field Probes
Field Probe Range of frequency Reading
ELECTRIC FIELD PROBE EP-1B-01 100 kHz – 3 GHz 0.2 – 200 V/m
TRI-BAND ELECTRIC FIELD PROBE EP-3B-01 100 kHz – 3 GHz 0.2 – 200 V/m
MAGNETIC FIELD PROBE HP-1B-01 10 Hz – 5 kHz
50 nT – 200
µ
T
QUAD-BAND ELECTRIC FIELD PROBE EP-4B-01 100 kHz – 3 GHz 0.03 – 200 V/m
ELECTRIC FIELD PROBE EP-1B-03 100 kHz – 7 GHz 0.2 – 200 V/m
QUAD-BAND ELECTRIC FIELD PROBE EP-4B-02 100 kHz – 7 GHz (0.03) 0.2 – 200 V/m
ELECTRIC FIELD PROBE EP-1B-04 10 Hz – 5 KHz 5 V/m – 20 kV/m
ELECTRIC FIELD PROBE EP-1B-05 300 kHz – 18 GHz 0.5 – 800 V/m
ELECTRIC FIELD PROBE EP-1B-06 300 kHz – 40 GHz 0.5 – 800 V/m
ELECTRIC FIELD PROBE EP-1B-08 100 kHz – 8 GHz 0.2 – 200 V/m
ELECTRIC AND MAGNETIC FIELD
SHAPED PROBE EHP-2B-01
E: 500 kHz – 9.25 GHz
H: 20 MHz – 1 GHz
E: 0.1 (0.5) – 1000 %
H: 0.3 (1.5) – 1000 %
ELECTRIC AND MAGNETIC FIELD
SHAPED PROBE EHP-2B-02
E: 500 kHz – 60 GHz
H: 20 MHz – 1 GHz
E: 0.1 (0.5) – 1000 %
H: 0.3 (1.5) – 1000 %
ELECTRIC AND MAGNETIC FIELD
SHAPED PROBE EHP-2B-03
E: 1.34 MHz – 9.25 GHz
H: 1 MHz – 1 GHz
E: 0.1 (0.5) – 1000 %
H: 0.3 (1.5) – 1000 %
ELECTRIC AND MAGNETIC FIELD
SHAPED PROBE EHP-2B-04
E: 1.34 MHz – 60 GHz
H: 1 MHz – 1 GHz
E: 0.1 (0.5) – 1000 %
H: 0.3 (1.5) – 1000 %
With EHP-2B-XX weighted models of field probes, after selecting the
desired limit, the meter gives the percentage of level referred to it.
Probes belonging to this group allow measurements compensation
based on frequency.
If the frequency of the signal to be measured is known, it is possible
to apply an automatic flatness correction, and the LR-01 is also able
to properly switch between linear and quadratic detection, as the
selected standard requires, depending on the frequency. In other
words, the field level evaluation becomes linear under 10 or 30 MHz,
depending on the selected standard.