Smartwatch
8-1
8 – Using of LR-01 with WearOS (Smartwatch)
Operating instructions
8.1 Introduction
This section provides the information necessary to use the LR-01
programmable Logger Repeater with the optional Smartwatch.
8.2 Installation
Download and install the LR01 Manager application on your smartwatch
from Google or Apple store.
Once the application is successfully installed, swipe
Upwards
on the watch
screen the user will be able to view the LR01 Manager icon displayed on the
Apps screen.
WearOS release 3.0 or higher must be installed on the Smartwatch to
use the LR01 Manager .
If the App has already been installed, tap on
Recent Apps
and make
sure the software is not running to avoid communication errors (see §8.3.4
Close the App).
Also make sure turning on Bluetooth wireless on LR01 and Smartwatch.
To active the Bluetooth communication on the LR01, the user must
connect the meter to Narda Probe Manager software and enable the
BLE function (see §4.2.10.1.4 Communications at Page 4-28).
Turn on LR-01 and wait some seconds while the instrument performs a
diagnostic test (see §2.7). After that it begins
flashing green
, to indicate
the instrument is ready to communicate.
Tap on the LR01 Manger icon
to run the application; a welcome screenshot
will show for a few seconds, then the “Searching for LR01” indication
appears.
1
Document LR01EN-30604-2.10 -
NARDA 2023
Summary of Contents for LR-01
