Napco iSecure Security System
All technical manuals are available in PDF format at
tech.napcosecurity.com
21
6. Install Smoke Sensors (cont'd)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference re-
ceived, including interference that may cause undesired operation.
Caution:
Changes or modifications
not expressly approved by manufacturer could void the user's authority to operate the equipment.
This smoke detector has a
Silence
feature that will allow the User to temporarily silence the sounder of a
detector in alarm. To activate
Silence
, hold down the
TEST
button for 10 seconds.
IMPORTANT:
The
detector will chirp every 30 seconds while in
Silence
mode and will automatically exit this mode after 5
minutes. (
Note:
If smoke is still present in the chamber after exiting
Silence
mode, the detector will go
into alarm again).
IMPORTANT!
Use proper polarity when installing the 3V lithium battery.
Always
install the
negative
end first as shown below:
1
.
Place negative end in first.
2
.
Push down on positive end
PUSH TO INSERT
(To remove battery, pull up on pos [+] end)
3
.
Press and hold
TEST
button for 5 seconds to
activate the internal sounder, send a supervi-
sory check
-
in (but NOT an alarm), and clear
the low battery trouble from the ISEC
-
SMOKE.
4
.
Separate Test (optional):
Press and hold
TEST
button (see page 20 for location) for 10
seconds to activate the internal sounder, send
an alarm and clear the low battery trouble.
No-
tify central station of impending test (if sys-
tem is monitored).
Note:
While holding the
button down, the LED will start to flash rapid-
ly indicating it is about to go into alarm. Test
system weekly with unit mounted.
continued
•
See page 48 for full programming information
