User’s Guide ValueJet 1608 HS
Safety instructions
AP-75810 - Revision 2.0
11
1
1.3
Handling inks / cleaning or waste fluids (cleaning & ink)
Before handling inks/ cleaning and their waste, do carefully read the MSDS-sheet and
the container labels for important health, safety and environmental information.
Only use original manufacturer's ink and appropriate cleaning liquid.
Before installing the ink pack, shake it gently. Doing so will preserve print quality.
To avoid ink separation, please remove and
shake all ink packs gently once a week
. To
gently shake the ink packs, rotate them side to side at least 2 or 3 times. Then, turn the ink
pack upside down and rotate side to side another 2 or 3 times.
When moving ink from a cold place to warm place, keep the ink for three hours or more in
the new printing environment before printing.
Inks
General advice: wear safety glasses and gloves especially when handling the waste
ink.
After spill: remove contaminated clothing.
After inhalation: if difficulties occur after vapour/aerosol has been inhaled, remove to
fresh air and seek medical attention.
After skin contact: wash thoroughly with soap and water.
After eye contact: wash affected eyes for at least 15 minutes under running water while
eyelids held open.
After swallowing: rinse mouth and drink plenty of water. Never induce vomiting.
Do not disassemble ink container. Otherwise, ink may get in your eyes or on your skin.
Also a disassembled ink container can not be used.
When refilling ink, use original manufacturer's ink. This printer is designed to use genuine
ink. When using non-original manufacturer’s ink,
printing might become blurred and the end of the ink in the container might not be
detected correctly
any problems caused by using ink other than those recommended above will not be
covered by the warranty, and repair expenses will be paid by the customer.
For handling waste: see section 13 on the MSDS-sheet