User’s Guide ValueJet 1608 HS
Printer menu
AP-75810 - Revision 2.0
105
5
5.4
Panel Setup Menu
5.4.1 Menu
1:
Setup
In the table below you will find the complete menu structure and its functions.
Setup item
Description
Set 1: MediaType
Set up the media type for printing
Set 2: Effect
Set up the effect menu
Set 3: Spitting
Set up the spitting operation while printing
Set 4: Side Margin
Set up the right and left margin when printing
Set 5: Media initial
Set up whether the media width and edge are detected when
initializing the media.
Set 6: Media Width/
MediaWidth Check
Specifies the media width between the loading mark and the left
end if not performing a media detection during initialization.
Displays the detected media width if performing a media
detection during initialization.
Set 7: Take-up
Set to on when using a take-up system
Set 9: Origin
Set the start position of the printing data
Set 10: Prev. Stick
Set up to prevent media from sticking when printing.
Set 11: Media heat
Perform the setting for the heating operation of the air heater.
Set 12: Head travel
Set up the distance to move the print head while printing.
Set 13: Multistrike
Set up the multi strike per swath.
Set 14: strike wait
Set up the waiting time while overwrite printing
Set 15: Slant Check
Set up the slanting detecting between two consecutive print jobs.
Set 16: Auto Cleaning
Set up the auto cleaning time while printing.
Set 17: Ink Status
Displays the remaining ink level of the ink cassette.
Set 18: Roll Length
Set up the roll media length.
Set 19: Longstore
Perform a longstore
Set 20: CR Maintance
Unlocks the carriage from the home position to clean the wiper.
Set 21: Initialization
Restores the print parameter values to the factory defaults.
Set 22: Life Times
Display the operational life time of each part
Set 23: IP Address
Set the IP address of the printer
Set 24: Subnet Mask
Set the subnet mask of the printer
Set 25: Gateway
Set the Gateway.
Set 26: BtmInterlace
Sets the BtmInterlace function.
Set 27: On cleaning
Perform a cleaning cycle at power up.
Set 28: Temporary
The settings of “OFF” or “ALL OFF” are displayed in the setup
menu temporary.
---
CANCEL
: shifts to the previous hierarchy.