Muller Elektronik DRILL-Control, Installation And Operating Instructions Manual

Page: 4 / 58

Contents
4 V3.20151130_rev.2 30283620-02-EN
7.6 Adjusting the target rate during operation 25
7.7 Using tramline control 25
7.7.1 Configuring the tramline control 26
7.7.2 Determining the machine type 26
7.7.3 Selecting tramline rhythm 27
Creating an even tramline rhythm 28
Creating uneven tramline rhythms 32
Creating special tramline rhythms 33
7.7.4 Programming individual tramline rhythms 36
7.8 Operating the hydraulic system with the job computer 36
7.8.1 Operating bout markers 36
7.8.2 Using the waterhole mode 37
7.9 Viewing results 38
7.9.1 Results 38
7.9.2 Total results 38
8 Configuring the on-board integrated display/controller for work 40
8.1 Selecting and configuring the speed source 40
8.1.1 Calibrating the speed sensor with the 100m method 40
8.1.2 Entering the simulated speed 41
8.2 Associating products with a hopper 41
9 Configuring the implement equipment 42
9.1 General information on the configuration 42
9.1.1 Performing the configuration 42
9.1.2 Layout of the configuration screen 42
9.1.3 Sequence of the configuration 43
9.1.4 Configuration of individual implement parts 43
9.2 Configuration of the implement 44
9.2.1 "Number of rows" parameter 44
9.2.2 "Tramline system" parameter 44
9.2.3 "Bout marker" parameter 44
9.2.4 "Waterhole Mode" parameter 44
9.3 Configuration of the hopper 44
9.3.1 "Upper Level Sensor" parameter 44
9.3.2 "Lower Level Sensor" parameter 44
9.4 Configuration of the metering units 44
9.4.1 "Gear ratio" parameter 45
9.4.2 "Pre-start time" parameter 45
9.4.3 "Early Stop Time“ parameter 45
9.5 Configuration of the rows 45
9.5.1 "Associated tramline" parameter 45
9.6 Configuration of the sections 45
9.6.1 "Working width" parameter 46
10 Using the system functions of the on-board integrated display/controller 47
10.1 Creating screenshots 47
10.2 Exporting a configuration 47