11
Troubleshooting
Performing diagnostics
50
V3.20151130_rev.2
30283620-02-EN
Currently measured current flow of the function. The value of the power measurement always
increases or decreases proportionally.
Example: The faster an electric motor is turning, the higher the value of the power measurement
▪ "
Input
"
– "
low
"
The function is deactivated. There is no voltage at the input.
– "
high
"
The function is activated. There is voltage at the input.
You can enter the following settings:
▪ "
Output value LS
"
– "
PWM
"
Depending on the entered PWM value, you can test whether an electric or hydraulic motor
is turning at the entered PWM value.
– "
Rev.
"
Depending on the rpm, you can test how long it takes for an electric or hydraulic motor to
reach the defined rpm.
▪ "
Output value HS
"
– "
low
"
The function is deactivated. There is no voltage at the input.
– "
high
"
The function is activated. There is voltage at the input.
▪ "
Output value HS/LS
"
– "
low
"
The function is activated or deactivated. Depending on how the function is switched, there
either is voltage or not.
– "
high
"
– The function is activated or deactivated. Depending on how the function is switched, there
either is voltage or not.
▪ "
Full Bridge
"
With the respective selection, you can test the linear actuators.
– "
Stop
"
The function is deactivated. The linear actuator is not moving.
– "
+/-
"
The linear actuator is moving in one direction. The direction in which the linear actuator is
moving depends on the respective connection.
– "
-/+
"
The linear actuator is moving in one direction. The direction in which the linear actuator is
moving depends on the respective connection.
Seeding is stopped.
Procedure
