Configuring the implement equipment
Configuration of the rows
9
30283620-02-EN
V3.20151130_rev.2
45
1.
On the
"Settings / Implement"
screen, press:
>
⇨
You can configure the metering units.
"Gear ratio" parameter
For each metering unit, enter the gear ratio between the metering shaft and the motor shaft.
Example: A gear ratio of 50/1 means that the metering shaft must rotate 50 times for the motor shaft
to rotate once.
"Pre-start time" parameter
Enter the time by which the metering unit should start earlier when the pre-start function is activated.
If you start working within this time, the job computer takes over the control. If you do not start
working in this time, the metering drive switches itself off after this time.
"Early Stop Time“ parameter
Enter the time after which the metering unit should stop when the early stop function is activated.
When the function has been activated, the metering unit only stops after the entered time.
Configuration of the rows
This is how to call up the configuration screen:
1.
On the
"Settings / Implement"
screen, press:
>
⇨
You can configure the rows.
"Associated tramline" parameter
Enter the tramline with which the respective row is associated. If a row is not associated with a
tramline, select "No". Based on this, the metering unit reduces the percentage of the application when
switching the respective tramline.
▪
"1"
– left tramline
▪
"2"
– right tramline
Configuration of the sections
This is how to call up the configuration screen:
1.
On the
"Settings / Implement"
screen, press:
⇨
You can configure the sections.
9.4.1
9.4.2
9.4.3
9.5
Procedure
9.5.1
9.6
Procedure
