7
Operating the implement on the field
Operating the hydraulic system with the job computer
36
V3.20151130_rev.2
30283620-02-EN
Programming individual tramline rhythms
If you realize that the tramline rhythms stored do not match your work method, you can program an
individual tramline rhythm.
1.
On the work screen, press:
>
⇨
"
Settings / Tramlines
" screen appears.
2.
In the "
RhNo.
" field, select rhythm number "
999
".
⇨
All of the parameters for the stored tramline rhythms are hidden.
3.
Configure the "
Length
", "
Left
" and "
Right
" parameters for the individual tramline rhythm.
4.
The entered values remain on the screen even if you select a different tramline rhythm. To use
the individual tramline rhythm, you always have to select "
RhNo.
" "
999
".
Operating the hydraulic system with the job computer
The Müller-Elektronik job computer is used to adjust the position of the hydraulic valves so that the oil
pressure is routed to specified parts of the seeder.
When operating the seeder with the job computer, remember that the job computer cannot control the
oil pressure.
You have to use the control unit in the tractor to generate pressure in the system.
Operation with these systems can then look like this:
1.
Press a function key on the on-board integrated display/controller. For example,
for
the left-hand bout marker.
⇨
The function icon appears on the work screen. This confirms that the hydraulic valve is
ready and this function can now be controlled hydraulically.
2.
Actuate the control unit of the hydraulic system in the tractor that is responsible for the bout
marker.
⇨
The pressure builds up.
⇨
The left bout marker is lowered.
3.
If you now remove the pressure from the valve, the left-hand bout marker will be lifted.
⇨
The function icon must appear on the work screen, both when you lower the bout marker
and when you lift it.
The following sections explain which hydraulic functions can be operated with the job computer.
Operating bout markers
You can use bout markers as you work to mark a pass.
Function icon
Meaning
Only use the left bout marker. The bout marker is not changed when lifting
the implement.
7.7.4
Procedure
7.8
Example
7.8.1
