Control Panel Operations
MTS Exceed™ 22 Series Product Information
Operation
51
1.8
Commissioning
State
Rotate the commissioning state key switch on the control panel to enable the
commissioning state.
When the key switch is rotated to the horizontal position, the equipment is in
commissioning state. Under the commissioning state, protection device can be
opened to maintain and commission the equipment. In this case, the test
equipment can only perform pendulum fetching and placement actions, and all
other actions are invalid. The test equipment will not brake if the shield is opened
under the commissioning state, and the pendulum can be in free swing
movements. When the pendulum is in hanging state, be sure to protrude the
safety pin manually. The commissioning state icon is displayed on the upper right
of the main unit control page, as shown in the figure below:
★
Note: Only qualified and trained personnel are allowed to perform
commissioning. The commissioning state is primarily used to install
commissioning bearing and pendulum on the test equipment to check the
equipment. When the commissioning is completed and the test equipment is in
testing state, be sure to pull out and well keep the key.
When the key switch is rotated to the vertical position, the equipment is in non-
commissioning state. In this case, if the shied is opened or the safety pin is
protruded manually, the equipment will immediately lock the pendulum device,
to avoid any accidents due to pendulum impact.
Summary of Contents for Exceed 22 Series
