OptiSwitch 2400/L3
Configuring
Interfaces
C
HAPTER
3
43
To enable Telnet or snmp management from a specific IP address
1
From the enable mode, enter the
configure terminal
command to begin configuration.
2
Type
interface
interface_name
3
Type
management [telnet][snmp]
ip_address/mask
OS2400(config)#
interface
vif1
OS2400(config-if)#
management telnet
194.90.137.254/24
Physical Port Configuration
The OptiSwitch-2400/L3 enables you to configure the physical
ports through various commands.
{
XE "Configuration:physical port"
}{
XE "Physical port:configuration"
}
Port Status
You can view the ports status using the
show port
command
optionally you can then specify the ports you would like to
examine. A sample
show port
list is displayed below:
{
XE
"Port:status"
}
OS2400#show port
PORTS CONFIGURATION
====================
PORT LAN_TYPE LINK PHY SPEED_SEL LAN_SPEED DUPLEX STATE
-----------------------------------------------------------------------
1.1 ETH10/100 OFF TP AUTO - - ENABLE
1.2 ETH10/100 OFF TP AUTO - - ENABLE
1.3 ETH10/100 OFF TP AUTO - - ENABLE
1.4 ETH10/100 OFF TP AUTO - - ENABLE
M.1 ETH10/100 OFF TP AUTO 100MBPS FULL ENABLE
M.2 ETH10/100 OFF TP AUTO - - ENABLE
Port Speed Configuration
The CLI enables you to configure the router port speed.
{
XE
"Configuration:port speed"
}{
XE "Port speed:configuration"
}{
XE
"Port:speed"
}
