MR ETOS IM, Operating Instructions Manual

Page: 95 / 412

7 Operation
Maschinenfabrik Reinhausen GmbH 2019 95 5163667/06 EN ETOS
®
IM
Setting the TLS version
You can use this parameter to set the accepted TLS versions. If you would
like to establish an encrypted connection to the visualization, you must use
an accepted TLS version. You can select the following options:
Option Accepted TLS versions
>= 1.0 ▪ 1.0
▪ 1.1
▪ 1.2
>= 1.1 ▪ 1.1
▪ 1.2
>= 1.2
1)
▪ 1.2
Table 14: TLS version
1)
This option can be selected only if the TLS versions are supported by the
connected peripheral equipment.
To set the TLS version, proceed as follows:
1. Go to Settings > Parameters > General > TLS version .
2. Select the desired option.
3. Press the Accept button to save the modified parameter.
7.2.2 Activating/deactivating automatic launch of commissioning
wizard
You can use this parameter to set whether the commissioning wizard
[
► Section 6.4, Page 90] is to launch automatically when the device is
restarted.
1. Go to Settings > Parameters > General > Commissioning wizard .
2. Select the desired option.
3. Press the Accept button to save the modified parameter.
7.2.3 Setting measured value display
This parameter lets you set whether the displayed measured values and
control parameters are to refer to the primary side or secondary side.
To set the measurement transformer display, proceed as follows:
1. Go to Settings > Parameters > General > Measured value display .
2. Select the option you want.
3. Press the Accept button to save the modified parameter.