EDS-405A/408A Series User’s Manual
Featured Functions
3-31
NOTE
The Turbo Ring DIP Switches located on the
EDS-405A/408A’s outer casing can be used to
configure the EDS’s Turbo Ring protocols. (For
details on how to do this, refer to “Configuring Basic
Settings—Turbo Ring DIP Switch” section in this
manual.)
If you use the web interface, console interface, or
Telnet interface to enable the Turbo Ring DIP
Switches, and then set DIP Switch 4 on the switch’s
outer casing to the “ON” position, you will not be able
to use the web interface, console interface, or Telnet
interface to change the status of the DIP Switch. In
this case, the
Communication Redundancy
settings
will be “grayed out” in the web browser as shown in
the following figure:
The Turbo Chain Concept
Moxa’s Turbo Chain is an advanced software-technology that gives network administrators the
flexibility of constructing any type of redundant network topology. When using the “chain”
concept, you first connect the Ethernet switches in a chain and then simply link the two ends of the
chain to an Ethernet network, as illustrated in the following figure.
Turbo Chain can be used on industrial networks that have a complex topology. If the industrial
network uses a multi-ring architecture, Turbo Chain can be used to create flexible and scalable
topologies with a fast media-recovery time.
Setting Up Turbo Chain
1.
Select the Head switch, Tail switch, and Member switches.
2.
Configure one port as the Head port and one port as the Member port in the Head switch,
configure one port as the Tail port and one port as the Member port in the Tail switch, and
configure two ports as Member ports in each of the Member switches.
3.
Connect the Head switch, Tail switch, and Member switches as shown in the diagram.
The path connecting to the Head port is the main path, and the path connecting to the Tail port is
the backup path of the Turbo Chain. Under normal conditions, packets are transmitted through the
Head Port to the LAN Network. If any Turbo Chain path is disconnected, the Tail Port will be
activated to continue packet transmission.
