![background image](http://html1.mh-extra.com/html/mortara/surveyor-central-3-x/surveyor-central-3-x_service-manual_1836784033.webp)
Section 3
3-7
System Receiver Module Verification
After verifying one of the receiver modules meets specifications during the previous “Signal Strength
Verification” testing, the test transmitter should be mapped to each of the separate receiver modules
installed in the system hardware.
Each receiver module should be checked for proper operation, making sure that the signal strength level
measures >-80db and the ECG waveforms do not show signs of distortion or drop out with the transmitter
placed at location #1 from the previous test.
System Transmitter Verification
Turn on the ECG simulator and connect it to one transmitter at a time from location #1 defined in the
previous tests. Start a monitoring session on the monitoring slot that matches the channel of the transmitter
being tested and verify the ECG quality is clean with out dropout and has a signal strength >-80db.
Repeat this test for all system transmitters.
S12/S19 Connection Verification
This section assumes that the S12/S19 Multi Parameter Monitor have been configured to communicate to
the Surveyor Central system via a network connection. Please refer to the S12/S19 manuals regarding
configuration of the unit.
Connect the S12/S19 to the Surveyor Central network
Turn the monitor on
Connect a simulator the the S12/S19 and verify that waveform is dispalyed
Verify that the waveform is displayed on the Surveyor Central display.
Summary of Contents for Surveyor Central 3.x
Page 4: ...iii...
Page 16: ...Surveyor Central 2 2 Note The Telemetry Nodes are computers that contain the PCI RF Boards...
Page 26: ......