![background image](http://html1.mh-extra.com/html/mortara/surveyor-central-3-x/surveyor-central-3-x_service-manual_1836784029.webp)
Section 3
3-3
Audible Alarm Testing
Equipment needed:
X12+/T12(S) transmitter, patient cable, patient simulator.
Alarm Volume Testing
Select the
Configuration Menu and enter a password to proceed. Click on the “Volumes” button and then
select “Sound Level”. Note what the sound level is set to, so it can be returned to this setting after the
volume testing is completed. Select the different volume o
ptions and click on the “Confirm” button to test the
audible level of the alarm. Once the levels have been tested, return the level to its original setting.
Alarm Trigger Testing
Admit a patient on the control system for the appropriate channel that you have configured your test
transmitter. Verify the “ECG Leads Off” alarm is set to ON for the admitted patient by selecting Alarm
Settings, then Technical Alarms. If the “ECG Leads Off” setting is set to OFF, temporarily change the
setting to ON to perform this test. Disconnect a lead from the patient simulator and verify that an alarm
begins to sound at the appropriate sound level set in the previous step (be sure to reset the alarm control
settings to where they were prior to performing this test).
UPS Test / Battery Replacement
Be sure patient monitoring is not in progress. Remove the mains plug from the UPS; the Central Station
must continue to function for 5 minutes without losing power. If the system can not be powered by the UPS
for a period of 5 minutes, the UPS may require repair or internal battery replacement.
Mortara recommends replacing the internal batteries on the UPS units provided by Mortara when the RED
“Battery End of Life” indicator is illuminated or every 3 years.
Summary of Contents for Surveyor Central 3.x
Page 4: ...iii...
Page 16: ...Surveyor Central 2 2 Note The Telemetry Nodes are computers that contain the PCI RF Boards...
Page 26: ......