User Reference Guide
SST-PB3-REM
186
Explicit Messaging
©2014 Molex Inc.
Document Edition: 1.1.4.0, Document #: 715-0106, Template Edition: 1.1, Template #: QMS-06-045
Use, duplication or disclosure of this document or any of the information contained herein is subject to the restrictions on page ii of this document.
Get_Attribute_Single 0x0E
Read I/O and status data see Table 1.3-1:
Exclusive Owner Connections for more
details.
Note
Writing to an assembly that belongs to an implicit connection will fail.
Reading is always allowed.
Note
After writing a command, clear the command by first waiting for the
Command Reply Register to echo the command and then write 0 to it.
Clearing it to zero after will stop the console from executing the
command when a command is executed in console.
9.1.4 Sending Explicit Messages to the Basic Diagnostics Object
Basic Diagnostics Object (Class Number 0x66, Instance 0 - 1, Attribute 0) – The object allows
the controller or EtherNet/IP Scanner to read diagnostic information. The object can be accessed
by using the following explicit message:
Service Name
Service
Code
Description
Get_Attribute_All
0x01
Read the current state of SST-PB3-REM
(see section 4.8.10, Module
Diagnostics).
9.2 DP-V1 Explicit Messaging
9.2.1 DP-V1 Class 1 Read Command
This command reads data from a DP-V1 slave using Slot_Number and Index parameters.
In RSLogix5000 a MSG instruction of the CIP generic message type should be used.
Table 9.2-1: CIP Generic Message Parameters
Value
Message Parameter Name
0x64
Object
0x52
Service
1
Instance
8
Length
