Moeller S40-AM-TL, Manual

Page: 97 / 113

Error Codes
94
10/00 AWB27-1301-GB
35 53 Incorrect data length for “fixed length frames”
The parameter entered at function block input “fixed_length” is equal to 0 or
exceeds the parameters set for the data array offset address.
Check the parameters and enter an admissible value for “fixed_length”.
36 54 Incorrect data length or offset address
Addition of the parameters entered at the function block “variable_length” and
“source_offset” or “destination_offset” inputs exceeds the value of the constant
“dfl_max” set in the variable declaration.
Check the parameters and enter an admissible value for “variable_length” or
“source_offset” or “destination_offset”.
The inadmissible value “0” was entered at the “variable_length” function block
input. Enter an admissible value.
If the error message occurs when you are accessing the flash memory or RAM
memory card (service 13 or 16), then an inadmissible value (> 128 bytes) was set
for the data length.
37 55 Subaddress too high
The parameter entered at the function block input “subaddress” exceeds the value
of the constant “sub_max” set in the variable declaration.
Check the parameters and enter an admissible value for “subaddress”.
38 56 Parameter error “baud rate”
The parameter entered at the function block input “baudrate” is inadmissible.
Select a valid baud rate value from the module’s manual.
39 57 Parameter error “character format”
The telecontrol module/card was programmed with the wrong character format.
Switch the controller off and on again to rectify the error.
3A 58 Parameter error “frame type”
The telecontrol card/module was programmed with the wrong frame type.
Switch the controller off and on again to rectify the error.
3B 59 Signal quality error DCD evaluation
The modem’s signal quality monitoring function has signalled a fault on the DCD
line.
Check your telephone line.
3D 61 No DSR signal
The connected modem is not ready.
Check that the connected modem is working correctly.
Error code Description
hex dec