Moeller S40-AM-TL, Manual

Page: 96 / 113

93
10/00 AWB27-1301-GB
6 Error Codes
The error codes are always sent in the status message as an
acknowledgement from the secondary station to the primary
station. They are displayed via the FB “fail_code” output.
The “fail” and “fail_stationaddress” outputs provide further
information on the error status and the station at which the
error occurred.
Primary station
Table 14: Error messages at the primary station
Error code Description
hex dec
30 48 PS416-TCS-200 telecontrol card is not operational
The telecontrol card is not installed or is in the wrong slot.
Check that the PS416-TCS-200 card is correctly installed in the rack. The slot
address “slotnumber” set in the function block must be the same as the slot actually
occupied by the PS416-TCS-200 in the rack.
31 49 Invalid command
The code associated with the function block “command” input is invalid.
Select a valid code number from Table 7 Page 38.
32 50 Invalid station address
There is no equivalent secondary station address for the station address set in the
primary station.
Check that the station addresses for the secondary stations and the primary station
are correct.
33 51 No station address set
No entries were made for the function block inputs “address_of_station_n” at the
primary station.
Enter the addresses programmed for the secondary stations at the
“address_of_station_n” function block inputs at the primary station.
34 52 Parameter “fixed_length” incorrect
The value entered at the function block input “fixed_length” does not agree with
the parameters on the card/module. Carry out a block reset or a warm or cold start
in order to transfer the modified value to the card/module.