Mitsubishi MOTORS OUTLANDER SPORT/RVR 2022, Owner'S Manual

Page: 306 / 535

(305,1)
[ Edit: 2021/ 2/ 10 Model: DG-D ]
2. Select “Blind Spot” and push the scroll dial.
3. Select “Active Assist (ABSA)” and push
the scroll dial.
4. Press the MI-PILOT Assist switch to turn
the system on or off.
NOTE:
Turning on the MI-PILOT Assist system will
turn on the LDP and ABSA system at the
same time. For additional information, see
“Lane Departure Prevention (LDP)” (P.5-
38).
Turning the BSW system off will deactivate
the ABSA system at the same time.
ABSA SYSTEM LIMITATIONS
WARNING
Listed below are the system limitations for the
ABSA system. Failure to operate the vehicle in
accordance with these system limitations could
result in serious injury or death.
.
The ABSA system cannot detect all vehi-
cles under all conditions.
.
The radar sensors may not be able to
detect and activate ABSA when certain
objects are present such as:
— Pedestrians, bicycles, animals.
— Vehicles such as motorcycles, low
height vehicles, or high ground
clearance vehicles.
— Vehicles remaining in the detec-
tion zone when you accelerate
from a stop.
— Oncoming vehicles.
— A vehicle merging into an adja-
cent lane at a speed approxi-
mately the same as your vehicle.
— A vehicle approaching rapidly
from behind.
— A vehicle which your vehicle
overtakes rapidly.
— A vehicle that passes through the
detection zone quickly.
.
The radar sensor’s detection zone is
designed based on a standard lane width.
When driving in a wider lane, the radar
sensors may not detect vehicles in an
adjacent lane. When driving in a narrow
lane, the radar sensors may detect vehicles
driving two lanes away.
.
The radar sensors are designed to ignore
most stationary objects, however objects
such as guardrails, walls, foliage and
parked vehicles may occasionally be de-
tected. This is a normal operation condi-
tion.
.
The following conditions may reduce the
ability of the radar to detect other vehicles:
— Severe weather
— Road spray
— Ice/frost/dirt build-up on the ve-
hicle
.
Do not attach stickers (including transpar-
ent material), install accessories or apply
additional paint near the radar sensors.
These conditions may reduce the ability of
the radar to detect other vehicles.
.
The camera may not detect lane markers
in the following situations and the ABSA
system may not operate properly.
— On roads where there are multi-
ple parallel lane markers; lane
markers that are faded or not
painted clearly; yellow painted
lane markers; nonstandard lane
markers; lane markers covered
with water, dirt, snow, etc.
— On roads where discontinued lane
markers are still detectable.
— On roads where there are sharp
curves.
— On roads where there are sharply
contrasting objects, such as sha-
dows, snow, water, wheel ruts,
Starting and driving
5-55
Condition: