Mitsubishi MOTORS i-MiEV, Owner'S Manual

Page: 167 / 297

Bluetooth® 2.0 interface (if so equipped)
5-58 Features and controls
5
5. When the disabling of the passcode is
completed, the voice guide will say “Pass-
code is disabled” and the system will
return to the main menu.
N00564700011
The Bluetooth
®
2.0 interface can use the
speaker enrollment function to create a voice
model for one person per language.
This makes it easier for the Bluetooth
®
2.0
interface to recognise voice commands said
by you.
You can turn a voice model registered with
the speaker enrollment function on and off
whenever you want.
N00564801149
It takes about 2 to 3 minutes to complete the
speaker enrollment process.
To ensure the best results, run through the
process while in the driver’s seat, in an envi-
ronment that is as quiet as possible (when
there is no rain or strong winds and the vehi-
cle windows are closed). Please turn off your
phone while in speaker enrollment to prevent
interruption of the process.
Use the following procedure for speaker
enrollment.
1. Stop your vehicle in a safe area, put the
selector lever in the “P” (PARK) position,
and then pull the parking brake lever.
2. Press the PICK-UP button.
3. Say “Voice training.”
4. The voice guide will say “This operation
must be performed in a quiet environment
while the vehicle is stopped. See the
owner’s manual for the list of required
training phrases. Press and release the
SPEECH button when you are ready to
begin. Press the HANG-UP button to can-
cel at any time.”
Press the SPEECH button to start the
speaker enrollment process.
5. The voice guide will prompt for phrase 1.
Repeat the corresponding phrase listed in
table “Enrollment commands” on page
5-72.
The system will register your voice and
then move on to the registration of the
next command. Continue the process until
all phrases have been registered.
6. When all enrollment commands have
been read out, the voice guide will say
“Speaker enrollment is complete.” The
system will then end the speaker enroll-
ment process and return to the main
menu.
Speaker enrollment function
Speaker enrollment
NOTE
 Speaker enrollment is not possible unless the
vehicle is parked. Make sure you park the
vehicle in a safe area before attempting
speaker enrollment.
NOTE
 If you do not start the speaker enrollment
process within 3 minutes after pressing the
SPEECH button, the speaker enrollment
function will time out.
The voice guide will say “Speaker enroll-
ment has timed out.” The system will then
beep and the voice recognition mode will be
deactivated.
NOTE
 To repeat the most recent voice training com-
mand, press and release the SPEECH button.
 If you press the HANG-UP button anytime
during the process, the system will beep and
stop the speaker enrollment process.
NOTE
 Completing the speaker enrollment process
will turn on the voice model automatically.

The commands “Help” and “Cancel” will not
work in this mode.
BK0220400US.book 58 ページ ２０１４年１１月１８日 火曜日 午前７時２７分