Mitsubishi Electric GOT SIMPLE GS2107-WTBD, User Manual

Page: 187 / 292

15.8 BACKUP/RESTORE
15 - 41
CONTROL
OF V
ARIOUS DA
TA
(DA
TA
CONTROL)
15
15.8.2 System configuration
This section describes the system configuration for the backup/restore function.
For connection type settings and precautions regarding the communication unit/cable and connection type, refer to the
following.
➠
GOT2000 Series Connection Manual (Mitsubishi Products) for GT Works3 Version1
■1.
Target controller
*1 Excluding the Q12PRHCPU, Q25PRHCPU.
*2 Use a PLC CPU with the function version of B or later.
*3 The backup/restore function cannot be used with the redundant CPU.
*4 To restore the backup data containing a special parameter, use the following version of CPU.
• FX3U(C) version: 3.10 or later
• FX3G(C) version: 2.00 or later
■2. Connection type
This function can be used in the following connection types.
( : Applicable, : Partly restricted, : Inapplicable)
*1 The LCPU does not support the connection type.
*2 When the GOT is connected to LCPU, use L6ADP-R2.
*3 Backup/Restore cannot be used when using CC-Link IE field network Ethernet adapter.
*4 The restoration cannot be performed to a QCPU with the factory-settings or whose memory is formatted.
■3.
Required hardware
The backup / restore, SD card is required.
■4.
Data to be backed up and restored
The following shows data to be backed up and restored.
Data other than the the following data cannot be backed up and restored.
(1) Basic model QCPU
*1 The file register in the Flash card installed in the CPU is always restored without confirming saving.
Select whether restoring or not the file register stored in the SRAM card or standard RAM in the dialog box displayed when
restoration is executed.
When the file register is not restored, the existing file register is deleted.
Therefore, programs of the controller may not work normally.
If a problem occurs in the operation of the controller after restoration, perform the restoration again, including to the file register.
Controller
QCPU(Q mode)
*1*2*3
LCPU
FXCPU
*4
Function Connection type between GOT and controller
Name Description
Direct CPU
connection
Computer link
connection
Ethernet
connection
Backup/restore
Backs up setting data for a controller
connected to the GOT and restores the data
to the controller.
*2 *4 *3*4
Item Description File name
Parameter Parameter for operating a programmable controller PARAM.QPA
Intelligent function
module parameter
Parameter for intelligent function modules IPARAM.QPA
Sequence program Program that the CPU operates MAIN.QPG
SFC program Sequence program with the SFC programming format MAIN-SFC.QPG
File register
*1
Data stored in file registers MAIN.QDR
Device comment Device comment to be stored in a programmable controller MAIN.QCD
Device initial value Setting the device initial value MAIN.QDI