Mitsubishi Electric GOT SIMPLE GS2107-WTBD, User Manual

Page: 185 / 292

15.7 Data Copy
15 - 39
CONTROL
OF V
ARIOUS DA
TA
(DA
TA
CONTROL)
15
POINT POINT POINT
When installing or removing an SD card
Always set [Permissions] on the GOT. For details, refer to the following.
➠
15.4 SD Card Access
■1.
Error display
When copying is not available between the GOT and the SD card, check the following contents according to the GOT
error display.
Step 6.
Copy is completed.
If the [ESC] button is touched, the
screen is closed.
If an error occurs during copy, an
error message appears.
For details of error messages, refer to
the following.
➠ Error display
When only the project data was
copied to the GOT, touch the [ESC]
button to restart the GOT and display
the user-created screen.
When the basic system application
was copied, the GOT will
automatically start up and display the
user-created screen.
(If the project data does not exist, a
message appears to notify that the
project data does not exist.)
Error message Remedy
SD card is not attached. Install an SD card to the GOT.
GOT type is unmatch.
The model set for the data in the SD card does not match with that of
the copy target GOT.
Use the same model data as that of the copy target GOT.
Write protection switch ON.
The write protection switch of the SD card is ON.
Turn off the write protection switch.
Available package data is notexisted.
There is no data to be a copy target in the copy source.
Store the data to be copied in the copy source and copy it again.
Touch