© Copyright
MINOS DIS TICARET LIMITED SIRKETI., 2017. All rights reserved. Reprinting, even of sections, only possible with the approval of
MINOS DIS TICARET LIMITED SIRKETI.
Document No: T-DYKM 1,5-2.2018_I.O.M./ Tarih: 09.07.2018
a. Make sure mixer is empty, then start the mixer.
b. Run mixer for at least five minutes at 3/4 of rated PTO RPM.
c. If unit is equipped with power chute, run discharge for 1 hour with no load
for proper motor break in.
d. Raise and lower the door and the chute or slide tray several times.
e. Disengage the mixer, turn off the tractor engine, and remove driveline.
f. Check the mixer drive components to be sure they are not abnormally hot.
● Always refer to Accident Prevention and Safety Instructions and Safety
Decal sections of this manual before operating this mixer.
● When the mixer is in operation, it has moving parts which could cause
severe injury or death to persons coming in contact with these parts. To
help avoid serious accidents, the following precautions should always be
followed:
● NEVER hand feed materials into mixer while it is running, always stop
engine and remove ignition key before hand loading materials. Rotating
augers inside mixer may not be visible from the loading point, and may cut
or grab hands, clothing, or material being loaded, causing severe injury.
● NEVER put hands, arms or feet inside unit, nor climb on or in the mixer
while it is running. Never allow anyone to position themselves near the
mixer or over or near the top of the mixer while it is running. Rotating
augers can grab clothing or create pinch points which can cause severe
injury or death to the operator or bystanders. Always stop engine and
remove the ignition key so that the mixer cannot be accidentally turned on
while inspecting, servicing, repairing, or cleaning.
29