© Copyright
MINOS DIS TICARET LIMITED SIRKETI., 2017. All rights reserved. Reprinting, even of sections, only possible with the approval of
MINOS DIS TICARET LIMITED SIRKETI.
Document No: T-DYKM 1,5-2.2018_I.O.M./ Tarih: 09.07.2018
The adjustment of the PTO shaft is necessary for different tractors.
To find out the right length:
● Connect the machine to the tractor. (See section 3.2.)
● Pull out the PTO shaft entirely and connect each separate half of the shaft to
the tractor and to the machine and then compare them with each other.
(Figure 8)
● Make sure that the PTO shaft tubes cover each other for at least 200 mm
when in maximal turning. When the tractor and the mixer feeder are in line
with regard to each other the PTO shaft must not touch the block. (There must
be at least 50 mm of space left).
● In case you need to shorten the PTO shaft, make sure you shorten both
shafts and protection tubes for exactly the same length.
Figure 8- Adjusting the PTO shaft to a suitable length.
Figure 9- Overall length of PTO shaft in closed position.
For example;
if the distance between
PTO shaft and machine gearbox
is 900
mm, and the distance (L) between the right and left pin of the P.T.O. shaft is
1000 mm (See Figure 9);
the amount to be cut from
both halves
of the P.T.O
shaft is 100 mm.
(Do not forget that this may seem like the shaft has been
25
