Mini CONVERTIBLE, Owner'S Manual

Page: 291 / 324

Warning
If the jumper cables are connected in the
incorrect order, spark formation may oc-
cur. There is a risk of injury. Pay attention
to the correct order during connection.
NOTICE
In the case of body contact between the
two vehicles, a short circuit can occur dur-
ing jump-starting. There is a risk of dam-
age to property, among other potential
damage. Make sure that no body contact
occurs.
Preparation
1. Check whether the battery of the other
vehicle has a voltage of 12 volts. The
voltage information can be found on the
battery.
2. Switch off the engine of the assisting
vehicle.
3. Switch off any electrical components in
both vehicles.
Jump-start terminals
The jump-start terminal in the engine com-
partment, refer to page 271 , acts as the
positive battery terminal.
Open the lid of the jump-start terminal.
The body ground or a special connection on
the body in the engine compartment, refer
to page 271 , acts as the negative battery
terminal.
Connecting the cables
To prevent personal injury or damage to
both vehicles, adhere strictly to the follow-
ing procedure.
1. Pull off the cover cap of the jump-start
terminal.
2. Attach one terminal clamp of the posi-
tive jumper cable to the positive battery
terminal, or to the corresponding jump-
start terminal of the vehicle providing
assistance.
3. Attach the terminal clamp on the other
end of the cable to the positive battery
terminal, or to the corresponding jump-
start terminal of the vehicle to be
started.
4. Attach one terminal clamp of the nega-
tive jumper cable to the negative bat-
tery terminal, or to the corresponding
engine or body ground of assisting vehi-
cle.
5. Attach the second terminal clamp to the
negative battery terminal, or to the cor-
responding engine or body ground of
the vehicle to be started.
Starting the engine
Never use spray fluids to start the engine.
1. Start the engine of the assisting vehicle
and let it run for several minutes at an
increased idle speed.
2. Start the engine of the vehicle that is to
be started in the usual way.
If the first attempt to start the engine is
not successful, wait a few minutes be-
fore making another attempt in order to
allow the discharged battery to re-
charge.
3. Let both engines run for several mi-
nutes.
4. Disconnect the jumper cables in the re-
verse order.
Seite 291
Breakdown Assistance MOBILITY
291
Online Edition for Part no. 01405A53AA0 - II/22