Minebea Intec PR 5220 Series, Instrument Manual

Page: 69 / 235

— Remote display Remote display
Selection: <none>, built-in RS-485
— Param Selection: Assigned to, Baudrate, Bits, Parity,
Stopbits, Mode
— ModBus RTU Selection: <none>, built-in RS-485
— Param Selection: Assigned to, Baudrate, Bits, Parity,
Stop bits, Slave-ID
— SMA Selection: <none>, built-in RS-485
— Param Selection: Assigned to, Baudrate, Bits, Parity,
Stopbits
— xBPI-Port Selection: <none>, built-in RS-485
— Param Selection: Assigned to, Baudrate, Bits, Parity,
Stopbits
— Application Selection: Standard, EasyFill
— PIN Access code, to protect the system setup from
unauthorized operation.
Input: 6 numerical characters
— SetTareKey Tare key
Selection: Tare&reset tare, tare&tare again,
disabled
— SetZeroKey Zero-setting key
Selection: only when not tared, reset tare on
zeroset, disabled.
— Fieldbus protocol Fieldbus protocol, display: depending on model
version
Only for PR 5220/01, ../04, ../06 and ../07, see
Chapter
7.15.3 .
— HW address MAC-ID, display: e.g.: 00:90:6C:31:1F:55
— Hostname
Unique device name, input: 2 24
alphanumerical characters
— Use DHCP Check the ☑ box to activate DHCP.
— IP address IP address, display: network address assigned
by the server
— Subnet mask Subnet mask, display: Mask for valid IP address
range
— Default gateway Standard gateway, display: IP number for
gateway
— Remote access Remote access to VNC client
— VNC client Access restriction, Input: authorized client for
instrument operation
7.11.1 Serial ports parameter
7.11.2 Operating parameter
7.11.3 Fieldbus parameter
7.11.4 Network parameter
Transmitter Series PR 5220 7 Commissioning
Minebea Intec EN-66