Nurse Call Set-up
User Maintenance
4 - 12
0070-10-0699-02
Accutorr V Operating Instructions
4.9
Nurse Call Set-up
1.
If needed, press
to return to the Normal display.
2.
Press
to display the SYSTEM SETUP dialog.
3.
Press
or
to highlight
MAINTENANCE
.
4.
Once
MAINTENANCE
is highlighted, press
to display the MAINTENANCE
dialog shown in FIGURE 4-5.
5.
Press
or
to highlight
NURSE CALL
.
6.
Once
NURSE CALL
is highlighted, press
to display the NURSE CALL SETUP
dialog shown in FIGURE 4-7.
FIGURE 4-7
NURSE CALL SETUP Dialog
7.
Press
or
to highlight the
SIGNAL DURATION
pull-down list.
8.
Once the
SIGNAL DURATION
pull-down list is highlighted, press
to select it.
9.
Press
or
to highlight
CONTINUOUS
or
PULSE
.
• CONTINUOUS sets the nurse call signal duration to the same as the alarm duration.
• PULSE sets the nurse call signal to a one (1) second pulse. When multiple alarms
occur, the monitor outputs only one pulse signal. If another alarm occurs before the
current alarm is cleared, the monitor will output another pulse signal.
10.
Once the selection is highlighted, press
to select it.
11.
Press
or
to highlight the
SIGNAL TYPE
pull-down list.
12.
Once the
SIGNAL TYPE
pull-down list is highlighted, press
to select it.
13.
Press
or
to highlight
NORMAL OPEN
or
NORMAL
CLOSE
.
NOTE:
SIGNAL TYPE is determined by the hospital nurse call
system.
14.
Once the selection is highlighted, press
to select it.
15.
Press
or
to highlight either
HIGH
or
LOW
for ALM LEV.
16.
Once an ALM LEV is highlighted, press
to select it.
17.
Press
or
to highlight either
TECH
or
PHYS
for ALM TYPE.
18.
Once an ALM TYPE is highlighted, press
to select it.
