MIMAKI ME-300STII, Operation Manual

Page: 67 / 90

Registering an Origin for the G-code Work Coordinates System
4-13
5
When you are done moving the X and Y
axes to the target positions, press
.
The current positions of the X and Y axes are regis-
tered into the selected work coordinates origin.
The values registered here are kept in memory even
after the power is turned off and then turned on again.
6
When you are done moving the Z axis to the
target position, press
.
The current position of the Z axis is registered into the
selected work coordinates origin.
The value registered here is kept in memory even
after the power is turned off and then turned on again.
7
Press or to return to
the screen in step 2 above.
To clear the registered origin
Press if you want to clear the values set for
the X and Y axes registered into the origin and return
the origin to the lower left corner of the machine.
Press to clear the registered origin and reset it to a point at the bottom left of the machine.
Press to return to the screen for setting the selected work coordinates origin without clear-
ing the origin.
If a G-code is set using an operation switch, you can register a work coordinate origin by using
the startup procedure previously described on How to Set X / Y Axis Origin (
P.3-6) or How
to Set Z Axis Reference Point( P.3-8).
In that case, however, among the Setting G-code Items ( P.4-10 ), only the Work Coordinate
origins for the coordinates system selected in the Work Coordinates system can be covered.
< W o r k . 1 > S p i n . O F F
X a x i s 0 . 0 0 mm
Y a x i s 0 . 0 0 mm
< W o r k . 1 > S p i n . O F F
Z a x i s 0 . 0 0 mm
< W o r k . 1 > S p i n . O F F
E N D k e y t o c l e a r
C E k e y t o c a n c e l