MIMAKI ME-300STII, Operation Manual

Page: 54 / 90

3-18
Daily Care
Cleaning this machine and surroundings
At the end of daily work, clean this machine and surroundings in the following way.
If a lot of waste is generated by the operation, clean them even when in operation.
1
Vacuum dust and chips on the table or surroundings with a cleaner.
When oil is used, wipe it off with a dry cloth. If stained badly, wipe it off with an alcohol-soaked cloth.
2
Remove the cutter, and then wipe around the spindle with a dry cloth.
3
If oil happens to attach to the operation panel, wipe it off with a dry cloth.
Do not clean this machine when the power is on.
Do not clean this machine while the power of this machine is on.
If the head or the table moves during cleaning, fingers could be pinched and cut between the
head cover and the side frame, or you could suffer abrasions or cut on the moving table.
Turn off this machine before cleaning.
Attention to the cutting edge of cutting blade
Please be careful when clean the cutting edge and touch the cutting blade.
The cutter blade is very sharp. There is a risk of injury such as cutting a finger.
Do not clean this machine with air gun.
Do not use an air gun to clean this machine.
If air is sprayed, waste may get into the precision part and may cause breakdown.
The waste also may get into the eyes or mouth of the worker who is cleaning or others around
this machine, and injure them.
For cleaning, use a vacuum cleaner.