How to Set Z Axis Reference Point
3-9
When the auto flat detection switch is OFF (automatic setting)
Detect the work to be engraved to set Z axis reference point automatically.
Before operating below, set the chip removal attachment and move the head onto the work.
1
Press
(or
) to display
the fourth page of the local mode.
2
Press
(or
) to display
the screen shown on the right.
*1
Press
to set the flatness correction
amount.
(
P.3-10)
If the flatness correction amount is not set, fourth line
is not displayed.
3
Press
(or
) to display
the screen shown on the right.
*1
4
Press
to display the screen
shown on the right. Then the machine starts
to detect the work surface.
(The cutter is lowered.)
5
When the work surface is detected, the
screen shown on the right appears, Z axis
reference point is set, and the operation is
completed.
(The cutter is raised.)
When engraving a work after setting as above, do not replace the cutter although the chip removal
attachment can be removed.
When the auto flat detection switch is ON or AUTO
The sensor automatically sets Z axis reference point. Set the flatness correction amount before that.
For the flatness correction amount, see
P.3-10.
*1. Press
on the step 2 and 3 to cancel it.
[ L C L ] S p i n - O F F 4 / 4
Z
S t a n d a r d
- - >
G - c o d e
- - >
G - c o d e
O r i g i n - - >
F 1
< Z
S t a n d a r d >
P l e a s e
s e t
f l a t n e s s
c o r r e c t
S e t t i n g
e n d
- >
F 3
< Z
S t a n d a r d >
X a x i s
0 . 0 0 mm
Y a x i s
0 . 0 0 mm
Z a x i s
0 . 0 0 mm
Z
S t a n d a r d
s e a r c h i n g !
Z
S t a n d a r d
s e t
Summary of Contents for ME-300STII
