Miele G 879 SCVI, Operating And Installation Instructions

Page: 17 / 76

Salt indicator.
When the salt reservoir is empty, the
“
8
k ” indicator lamp will light, notif-
ying you that the reservoir should be re-
filled with reactivation salt.
Once filled, the dishwasher will automati-
cally reactivate the softener when
necessary. The “
8
k ” indicator lamp
will light up whenever the reactivation
process is being performed.
Note:
If the water used is very soft (below 150
ppm (mg/l)), further softening is not re-
quired and the “
8
k ” indicator
lamp will remain lit. It can be disre-
garded or bypassed using the follow-
ing procedure.
The “
8
k ” button has also been de-
signed for future programme updates
(PC). See the “After Sales Service” sec-
tion for further details.
Bypassing the Salt indicator lamp.
In order to bypass the salt indicator
lamp, you will need a screwdriver and
needle nose pliers.
Remove ONLY the salt reservoir cap.
Looking into the salt reservoir, you will
see the top of the float chamber on the
right hand side
b
.
Using a screwdriver, carefully pivot
the float chamber towards the center
of the reservoir.
Using the needle nose pliers, first
pull the cap
c
off of the float cham-
ber, then remove the float
d
.
Replace the float chamber cap,
push the chamber back into its up-
right position, and replace the salt
reservoir cap. The indicator lamp will
now remain off.
Water Softener
17