4-2
Workstation 5 Field Service Guide
Remove and Replace the Workstation 5 FRUs
Disassembling the Workstation 5
Disassembling the Workstation 5
The following procedure describes how to disassemble the workstation and
access the system board and other internal components.
1.
Remove all cables from the I/O panel including the AC Power Cable
before disassembling the unit.
2.
Place a towel or other soft cloth on your work surface to protect the LCD
and touchscreen glass, then place the workstation face down on this
surface. If an optional fingerprint reader or other option is installed in the
Top Cover, avoid resting the unit on it.
o
The WS5 cover is held in place by a pair of captive screws accessible
from the underside of the unit as shown in Figure 4-1. A pair of hinges
are located at the rear of the base.
3.
Loosen the two captive screws from the under side of the unit as shown in
the upper half of Figure 4-1. Remove the top cover from the base by lifting
at the front of the cover as shown in the lower half of Figure 4-1. If an
optional Fingerprint Reader or other cabled device is attached to the top
cover, place it directly behind the base, as shown on the next page.
Figure 4-1: Removing the WS5 Top Cover
SHOCK HAZARD
Always remove the AC power cable from the unit
before
you open the cover.
