metrotek Bercut-ET, Operation Manual

Page: 100 / 116

100 Remote control
6.2 Remote control via TELNET
TELNET (Telecommunication Network) is a protocol to access and inter-
act with a remote network device. To configure test properties, to view the
current settings, and to perform measurements, use the commands described
in the Appendix B.
Remote control via TELNET is an optional functionality
1
. To control
remotely Bercut-ET via TELNET protocol, connect to the device via A(B)
port or the LAN port and then type in the following command in a console:
telnet IP-address of the port
. Default user name and password:
admin
.
6.3 Remote control via WWW-interface
Remote control via WWW-interface
2
function allows to view and save on
PC all the settings and results of the major tests.
To view results, connect to Bercut-ET via A(B) port or the LAN port,
and type the IP-address of connected port into the address line of your web-
browser.
To save the data press Download report . The data will be saved with
.csv extension.
Figure 6.1. RFC 2544 test results
1
Optional functionality. Not available in the basic configuration and should be ordered
additionally.
2
Optional functionality. Not available in the basic configuration and should be ordered
additionally.
Bercut-ET. Operations manual