48
Analysis. Typical tasks and solutions
Figure 5.44.
Src+Dst
swapping mode
5.9.2
Configuring L3 Loopback
Figure 5.45. Layer 3 parameters
•
Replace IP
— select the mode of IP addresses swapping:
– Off
— IP address swapping is disabled;
– Source
— swap
Source IP address
, see fig. 5.46;
– Destination
— swap
Destination IP address
, see fig. 5.47;
– Src+Dst
— swap both
Source IP address
and
Destination IP
address
, see fig. 5.48.
•
Source
— specify IP address that will substitute
Source IP Address
of
an Ethernet frame.
•
Destination
— specify IP address that will substitute
Destination IP
Address
of an Ethernet frame.
•
Replace
— select the mode of
ToS
swapping:
– Off
— swapping of
Type of Service
and
Precedence
values is dis-
abled;
– ToS
— swap
Type of Service
values;
– Precedence
— swap
Precedence
values;
Bercut-ET. Operations manual
Summary of Contents for Bercut-ET
