metrotek Bercut-ET, Operation Manual

Page: 110 / 116

110 Remote control commands
Table B.3. Remote control commands (TELNET). Configuration mode (continued)
Test traffic
txgen header src mac XX:XX:XX:XX:XX:XX set source MAC address
txgen header src ip i.i.i.i set source IP address
txgen header src udp text set source UDP-port number
txgen header dst mac XX:XX:XX:XX:XX:XX set destination MAC address
txgen header dst ip i.i.i.i set destination IP address
txgen header dst udp text set destination UDP-port number
txgen header vlan enabled off/on enable/disable VLAN parameter
txgen header vlan id text
set VLAN identifier
txgen header vlan priority text set traffic priority
txgen header precedence text set frame priority
txgen header tos 0000/1000/0100/0010/0001 set type of service for the packet
txgen port a/b set transmitting port
txgen frame int set frame size
txgen duration hh.mm.ss set trial duration
txgen rate set user-defined rate (Kbps or %)
Network setup
network a dhcp off/on
enable/disable DHCP option for
port A
network a ip i.i.i.i set IP address for the port A
network a subnetmask i.i.i.i set subnet mask for the port A
network b dhcp off/on
enable/disable DHCP option for
port B
network b ip i.i.i.i set IP address for the port B
network b subnetmask i.i.i.i set subnet mask for the port B
network gateway i.i.i.i set gateway IP address
network dns i.i.i.i
set IP address for the DNS network
node
Interface setup
gbe a speed automatic/10/100/1000
select the transmission rate for the
port A
gbe b speed automatic/10/100/1000
select the transmission rate for the
port B
Common commands
exit exit from the configuration mode
help show the list of available commands
Bercut-ET. Operations manual