Metronix ARS 2320, Product Manual

Page: 139 / 171

Service functions and error messages Page 139
Product Manual „Servo drives ARS 2320, ARS 2340, ARS 2320W, ARS 2360W“ Version 8.0
Error message Meaning of the error message Measures
Main
index
Sub
index
07 0 Overvoltage in the DC-bus Check connection to braking resistor (internal /
external).
External braking resistor overloaded?
Check rating.
08 0 Angle encoder error resolver See measures 08-2 .. 08-8.
1 Sense of rotation of the serial
and incremental position
evaluation is not identical A and B-track are mixed up?
Correct (check) the connection of the tracks.
2 Error of track signals Z0
Incremental encoder Angle encoder connected?
Angle encoder cable defective?
Angle encoder defective?
Check the configuration of the angle encoder
interface.
The encoder signals are disturbed: check the
installation for compliance with EMC
recommendations
3 Error of track signals Z1
Incremental encoder
4 Error of track signals of digital
incremental encoder
5 Error of Hall signals incremental
encoder
6 Communication error encoder
7 Signal amplitude incremental
track erroneous
8 Internal encoder error Internal monitoring of the angle encoder at [X2B]
has identified an error.
Communication error?
Check the encoder type, contact the Technical
Support if necessary.
9 Encoder at X2B not supported Please contact the Technical Support
09 0 Old encoder parameter set
(type ARS) Save data into the encoder EEPROM (new
format)
1 Encoder parameter set cannot
be decoded Encoder defect?
Check encoder interface configuration.
The encoder signals are disturbed.
Check the installation for compliance with EMC
recommendations
2 Unknown encoder parameter
set version Save the data into the encoder again.