Metos Culino Combi 40S, Installation And Operation Manual

Page: 33 / 58

15.6.2012 Rev. 1.7
Operating instructions
27
• The amount of water flown will stay on the display and the appliance reverts to the
basic mode by pushing either the automatic flow on/off or MAN/RESET button.
Interrupting the automatic filling of water
• The function is interrupted by pushing the automatic flow on/off button.
• The achieved value stays on the display and the decimal point is blinking.
• The set value is saved in the memory.
• In the interrupted mode, the setting can be changed using the “+”/”–” buttons.
• The water dispenser reverts to the basic mode by pushing either the automatic flow
on/off or MAN/RESET button.
• If the function is interrupted by pushing the emergency-stop button, the appliance
reverts to the basic mode and the settings must be done again.
Continuing the automatic water filling after interruption
• The filling will continue from the achieved value up to the set value by pushing the
automatic flow on/off button.
• After this the decimal point will illuminate continuously.
Error in automatic water filling
• If there is an error in flow measurement or if water does not flow, the value on the
display blinks.
• The water dispenser reverts to the basic mode by pushing either the automatic flow
on/off or MAN/RESET button.
Settings
Maximum filling amount
• The maximum filling amount has been set in the factory according to the kettle
size.
• The setting is changed by first pushing the “–” button and immediately after that
the “+” button for 5 seconds, after which the display value starts to blink. The new
setting value according to the kettle size is set using the “+”/”–” buttons. The max-
imum set value is 400 litres.
• The set value is saved if the setting is not changed in 5 seconds.
Calibration of flow measurement
• Basic calibration has always been done in the factory, so normally it need not be
done again.
• If, however, calibration is needed, first push the MAN/RESET button and imme-
diately after that the “–” button for 5 seconds, whereafter the value 855 starts to
blink on the display.
• To decrease the flow, push the “–” button, so the value decreases. To increase the
flow, push the “+” button, so the val ue increases. The amount of flow must be
checked by pouring 5 litres of water into a measuring vessel.
• The set value is saved if the value is not changed within 5 seconds.