Metos Culino Combi 40S, Installation And Operation Manual

Page: 32 / 58

15.6.2012 Rev. 1.7
Operating instructions
26
4.2.7 Automatic water filling (option)
A desired amount of cold water can be dispensed to the kettle by the automatic water dis-
penser in the following way:
• water filling is manually kept on until the desired amount of litres appears on the
display of the control unit
or
• automatic water running stops when the amount of litres set beforehand in the con-
trol unit are achieved.
1. 3-digit display
2. automatic flow on/off
3. manual flow + reset
4. setting is increasing
5. setting is decreasing
Basic mode
• The appliance is on when the kettle on-off switch is on; 0 appears in the last digit’s
position.
• Decimal point is illuminating.
• The set amount of filling has been achieved. The values are 0.
• If the function of the appliance is interrupted by switching off the control voltage,
the reswitching of voltage will always set it to this basic mode.
Manual water filling
• Filling starts when the MAN/RESET button is pushed and held down for the du-
ration of filling.
• The display is updated with an accuracy of one litre as long as the button is held
down.
• The achieved value in litres is shown on the display for 10 seconds after stopping
the filling. Then 0 appears on the display.
• If you want to continue filling within the mentioned time, the value on the display
will continue increasing.
Automatic filling of water
• Set the desired amount by pushing the “+” button (4). The set value appears on the
display.
• The value can be decreased by using the “–” button (5).
• The value is shown on the display for 10 seconds, whereafter the set value will be 0.
• Start the filling by briefly pushing the automatic flow on/off button while the set
value is illuminating on the display.
• After starting the filling function, the display will cumulatively show the amount
of water filled (in litres) and the flow stops automatically when the set value has
been achieved. The set value is reset to zero.