Merging Anubis Premium, User Manual

Page: 73 / 138

73
JACK 3/4: Physical TRS jack outputs 3 and 4 located at the back to the Anubis
Same parameters as above (XLR 1-2)
HEADPHONE 1: Headphone set 1 located at the front Anubis left side
Max Output Level: +9dBu or +18dBu
Attenuation*: +0dBu or -36dBu
Channel 1: Polarity setting
Channel 2: Polarity setting
HEADPHONE 2: Headphone set 2 located at the front right side of the Anubis
Same parameters as above (Headphones 1).
The Anubis digital to analog converters are designed to drive high or low impedance headphones
at high levels with significant audio output Power undistorted.
User should be attentive to the impedance of the headphones being used and set the Anubis
Max Output level accordingly.
Warning: It is not recommended for headphones with an impedance below 200 Ohms to select an
Output Level of +18dBu. As a preventive measure, a warning message will be displayed each time a
user changes the Output Level of the Headphones from +9dBu to +18dB
Warning : The Anubis Headphones output level can make your headphones very loud if it is turned
up too high, and that could cause permanent hearing damage. Please be careful with your ears when
using the +18dBu setting.
*As of Firmware 1.0.16 and higher. The Settings>Audio Outputs page no longer have per channel
output Trims. This was replaced by an Attenuation feature for the output pairs.
Trim / channel have to be done in the Monitor from now on.