COLD WEATHER OR EXTENDED STORAGE
80
4. Connect the remote outboard fuel tank to the inlet of the water
separating fuel filter.
5. Have the engine ready for flushing as explained in the
Flushing Cooling System
section of this manual (cooling
system flushing and the fuel system storage procedures are
performed together). Start and run the engine at 1000 RPM
for a minimum of five minutes or longer (if required) to
complete the fuel system preperation and the cooling system
flushing.
6. After the specified running time is complete, slowly return the
throttle to idle RPM and shut off the engine.
IMPORTANT: Maintain an adequate supply of the fuel/fogging
mixture in the remote 23 liter (6 U.S. gal) tank to complete the fuel
system treatment and flushing procedure. Do not let the remote
tank or fuel system run dry.
7. If fuel in the main tank(s) contains alcohol, (if fuel without
alcohol is not available) drain the fuel tank(s) completely and
add Gasoline Stabilizer and Conditioner to any fuel remaining
in the tank(s) before storage.
8. Close the fuel shut off valve, if equipped.
9. Change the engine oil and oil filter.
NOTICE
The universal joint bellows may develop a set when stored in a
raised or up position, causing the bellows to fail when returned
to service and allowing water to enter the boat. Store the
sterndrive in the full down position.
10.Place the drive unit in the full down position.
Summary of Contents for HP1200 SCi Dry Sump
Page 4: ...iv...
Page 8: ...viii...
Page 86: ...MAINTENANCE 78 Date Maintenance Performed Engine Hours...
