SPECIFICATIONS
21
Engine Break‑in
IMPORTANT: Failure to follow the engine break‑in procedures can
result in poor performance throughout the life of the engine and
can cause engine damage. Always follow break‑in procedures.
1 Hr. Break‑in Procedure
•
Do not exceed 5000 RPM
5 Hr. Break‑in Procedure
•
Allow engine to warm‑up for 3‑5 minutes.
•
Do not exceed 3/4 throttle.
•
Avoid full throttle acceleration from idle speed.
•
Always vary throttle setting.
•
Run engine the majority of time between 2500 ‑ 4500 RPM.
•
Frequently check engine oil level at reservoir sight tube. Add oil if needed.
It is normal for oil consumption to be high during break‑in period.
After Break‑In Period
To help extend the life of your power package, Mercury Marine
recommends the following:
After 5 hr. Break‑in
•
Use a propeller that allows the engine to operate at or near the top of the
maximum RPM range (See
Specifications
section) when at full throttle
with a normal boat load.
•
Do not advance the throttle until the engine runs smoothly at idle and water
temperature reaches a minimum of 54 °C (130 °F). Do not operate at full
throttle until the engine oil temperature reaches 60 °C (140 °F).
•
Follow the maintenance schedule in this manual.
Summary of Contents for HP1200 SCi Dry Sump
Page 4: ...iv...
Page 8: ...viii...
Page 86: ...MAINTENANCE 78 Date Maintenance Performed Engine Hours...
